Table of Contents
Advertisement
• Connect the appliance to the power supply in a
permanent way with an H07 RN-F type cable
dim. 3G1,5mmq;
• Install the power cable in a metal or rigid
plastic pipe without any sharp parts;
• Install ahead of the appliance an omnipolar
switch of suitable capacity with contact gap of
at least 3 mm. Install the switch in the
building's electrical system, in the immediate
vicinity of the appliance;
• If required by local standards and regulations,
a RCBO circuit breaker with Idn 300mA class
A must be provided in the power supply circuit
by the installer;
• Appliance max. leakage current is 0.75 mA;
• Install ahead of the appliance a device
(interlocked plug, lockable switch or similar
devices) lockable in the open position during
maintenance;
• Connect the appliance to an efficient earthing
system. For that purpose, the connection
terminal block has a terminal with the symbol
for connecting the earth wire;
• Also, include this device in an equipotential
system (see chap. F.6.3). Make sure the oven
on which the hood is mounted has the relevant
terminal. This terminal must be in electrical
contact with all fixed exposed metal parts of
the hood and must allow the connection of a
conductor having a nominal cross-section area
of 2.5 mm2 to 6 mm2; this connection is made
with the screw marked
near the power cable entry.
F.7.2 Power cable installation
To connect the power cable to the appliance,
proceed as follows:
1. Open the Technical Compartment;
2. Connect the cables (NOT SUPPLIED - see the
technical characteristics on F.7.1 - "Power
cable") on "VOLTAGE" female connector,
using the male connector supplied, following
the instructions the relevant Wiring diagram;
3. Close the Technical Compartment.
, located externally
F.7.3 Hood-oven interface cable
The hood is supplied with an Interface Cable, it is
already connected on main-board in CN3 position;
to connect the hood to oven proceed as follows:
1. Remove the left side panel of the oven, as
indicated in the "Oven Installation Manual";
2. Remove the pre-cut sheet on the oven base to
obtain a 21mm hole;
3. Insert the male thread curve supplied, relevant
to the interface cable, and secure it with the
nut supplied;
4. Remove the Touch Screen Panel from the
oven, as indicated in the "Oven Service
Manual";
5. Insert the interface cable connectors on the
relevant positions indicated X28-A;
19
Advertisement
Table of Contents
