NETGEAR DGN2200M User Manual page 10

N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Table 1. Front panel button and LED descriptions (continued)
Button/LED Activity
WiF Turn the wireless radio in the wireless modem router on and off. The wireless radio is on by
default. The LED located below this button indicates if the wireless radio is on or off.
Solid green
Blinking green
Off
Internet Port Solid green
Solid red
Blinking green
Blinking green and red
Off
DSL Solid green
Blinking green
Off
USB Off
Solid blue
Blinking blue
LAN Ports Solid green
Blinking
Off
Power Solid green
Solid amber
Off
Restore Factory Settings
button
Description
Indicates that the wireless port is initialized.
Data is being transmitted or received over the wireless link.
The wireless access point is turned off.
There is an Internet session.
There is no Internet connection.
Data is being transmitted over the Internet connection.
Traffic meter limit has been reached.
No Internet connection detected or device in bridge mode.
The ADSL port is synchronized with an ISP's network access
device.
Indicates ADSL training—ADSL is synchronizing with the DSLAM.
The unit is off, or there is no IP connection.
• No USB device connected.
• "Safely Remove Hardware" has been activated.
• An error has occurred with the device.
USB device is ready to use.
USB device is in use.
The local Ethernet ports have detected wired links with computers.
Data is being transmitted or received.
No link is detected on these ports.
The router is powered on and operating normally.
POST (power-on self-test) in progress.
Power is not supplied to the router.
Press the Restore Factory Settings button for 6 seconds. The
Power LED lights briefly. When the button is released, the LED
blinks red three times and then turns green as the router resets to
the factory defaults.
Internet Configuration
10