Table of Contents
Advertisement
Main Screen > Device Setting > Configuration Setting > Set
Click 'Set' to enable new settings. You must enter your password for these settings to be accepted.
Main Screen > Device Setting > Configuration Setting > Cancel
Click 'Cancel' to abort the above settings.
Main Screen > Switch Setting> > Password Change
1. Click 'Password Change' from the Switch Setting section. The following screen pops up as
shown in Figure 3-10.
Figure 3-10
•
New Password – Type any desired password. Passwords are case-sensitive and can have a
maximum of 20 characters.
•
Confirm Password – Re-type the new password to confirm it.
•
Old Password – The default password is 'password'.
2. Click Set to enable new password.
Main Screen > Switch Setting > Web Access
1. Select a listed switch from the Device List section. Then click Web Access from the Switch
Setting, see Figure •.
2. Enter the default password "password" and click Log in.
Smartwizard Discovery Program
GS700TS Series Smart Switch Software User Manual
v1.0, November 2006
3-5
Advertisement
Table of Contents
