Sharp AR-280 Service Manual page 96

41 - 3 Purpose Operation test/check
Function Used to check the operation of the document size sensor and the related circuit. (The document size sensor
(Purpose) output level can be monitored with the LCD.)
Section Others
Item Operation
Operation/ The detection output level of each sensor is displayed in real time.
Procedure
OCSW
PD*
* The value in [ ] shown at the right of each sensor name is the threshold value.
Note
43
43 - 1 Purpose Setting
Function Used to set the fusing temperature in each operation mode.
(Purpose)
Section Fixing (Fusing)
Item Operation
Operation/ 1. Select the kind of lamps and the operation mode with [↑], [↓] keys.
Procedure
2. Enter the set value with the 10-key.
3. Press the [OK] key to set the fusing temperature set in procedure 2.
Used to set the fusing temperature in the normal mode and in the power save mode.
INSIDE NORMAL:
OUTSIDE NORMAL:
INSIDE PREHEAT:
OUTSIDE PREHEAT: The control temperature in the manual copy mode when the side lamps are heated. (*2)
INSIDE MFT:
OUTSIDE MFT:
( ): Default
U.S.A. (Inch)
Canada (Inch)
Other (Inch)
Japan
Other (AB)
Europe (AB)
U.K. (AB)
Aus. (AB)
Note Be sure to set to the default value. If not, a trouble may occur.
Document cover state
Document sensor
The control temperature in the normal mode and when the center lamp is heated. (190)
The control temperature in the power save mode (pre-heat mode) and the side lamps are heated.
(190)
The control temperature in the manual copy mode when the center lamp is heated. (*1)
The control temperature in the manual copy mode when the center lamp is heated. (200)
The control temperature in the manual copy mode when the side lamps are heated. (200)
Destination
AR-230/280/285 series
AR-2X1/2X6/3X1/250 series
Pre-heat mode fusing temperature set value
MODEL
AR-330/335 series
AR-3X6 series
125 130
125 130
125 130
130 130
125 130
110 130
110 130
110 130
8 – 51
AR-405
AR-4XX series
140
140
140
140
140
140
140
140
1/21/1999