Other Devices - NETGEAR ProSafe GS104 Installation Manual

Install the Switch and Connect the
3
3

Other Devices

Apple G4
10/100/1000 Mbps Gigabit Switch GS104
On=10M, Blink=ACT
1 2 3 4
Power Green=FDX, Yellow=COL
GS104 4-Port 10/100/1000 Mbps
Gigabit Ethernet Switch
1. Place the switch on a flat surface or hook onto the screws.
2. For each device, insert one end of an Ethernet cable into the port in the device and insert
the other end into one of the Ethernet ports on the switch.
3. Connect the power adapter's cord into the back of the switch and then plug the adapter
into a power source (such as a wall socket or power strip).
The Power light
should light up.
The corresponding
Link LED for each
connected and
powered device
should light and flash when activity occurs. If the connection is 1,000 Mbps or 100
Mbps, the LED in the RJ-45 jack will light up. If the connection is 10 Mbps, the 10M
LED on the left side of the front panel wll light up.
Note: If any light doesn't operate as indicated, go to the Troubleshooting section.
PC with
GA302T
Adapter
Gigabit Gigabit
Ethernet 1000M 100M
1 2 3 4
Power ACT, FDX, COL LED
10/100/1000 Mbps Gigabit Switch
On=10M, Blink=ACT
1 2
Power Green=FDX, Yellow=COL
Model GS104 4-Port 10/100/1000 Mbps Gigabit Ethernet Switch
Server with GA622T
Auto
Uplink
FVS318 Cable/DSL ProSafe VPN Firewall
GS104
3 4
1
Adapter
LOCAL
10/100M
8 7 6 5 4 3 2 1
Gigabit Gigabit
Ethernet
2 3
DSL
modem
INTERNET
12VDC 1.2A
OFF ON
1000M 100M
LED LED
1000M 100M
Auto
Uplink
4