BenQ G Series User Manual page 21

2. Remove the cover of the cable management
system.
The stand arm also works as a cable management
system that helps keep the cables neat and clean. Slide
the cable cover up to align the marking on the cable
cover with the unlock icon on the stand arm. Remove
the cover as illustrated. You can have one power cord,
two video cables, and one audio cable routed together.
Pass a cable through the cable management hole on the
stand arm first while cabling. Start with the ones with
bigger connectors.
Allow enough cable length while cabling to avoid loose
connection and to save the pins or socket connectors from
being bent or broken.
3. Connect the power cable to the monitor.
Pass the cable through the cable management hole on
the stand arm first.
Plug one end of the power cord into the socket labelled
on the rear of the monitor. Do not connect the
other end to a power outlet just yet.
4. Connect the PC video cable
Do not use both DVI-D cable and D-Sub cable on the same
PC. The only case in which both cables can be used is if they
are connected to two different PCs with appropriate video
systems.
To Connect the DVI-D Cable
Pass the cable through the cable management hole on
the stand arm first. Connect the plug of the DVI-D cable
(at the end without the ferrite filter) to the monitor
video socket. Connect the other end of the cable (at
the end with the ferrite filter) to the computer video
socket.
Tighten all finger screws to prevent the plugs from
accidently falling out during use.
https://tm.by
Интернет-магазин TM.by
How to assemble your monitor hardware (for models without height adjustment stand)
1
2
Either
LINE IN
D-SUB
21