Bosch GSR18V-400 Operating/Safety Instructions Manual page 11

Inserting Bits
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to
grasp the spinning chuck.
1. Move reverse switch lever to the center
"OFF" position.
2. Remove battery pack and rotate the
clutch ring (Model GSR18V-400) or mode
selector ring (Model GSB18V-400) to the
drill bit symbol "
3. Rotate the chuck sleeve (1) counter-clock-
wise viewing from chuck end, and open
chuck to approximate drill bit diameter.
4. Insert a clean bit up to the drill bit flutes
for small bits, or as far as it will go for
large bits.
5. Close chuck (1) by rotating the chuck
sleeve clockwise and securely tighten by
hand (Fig. 4).
6. Return the clutch ring or mode selector
ring to desired position.
Belt Clip
self to avoid entanglement with surround-
ing objects. Unexpected entanglement could
cause the tool to fall resulting in injury to the
operator or bystanders.
The belt clip accessory (6) will allow you to
conveniently attach your tool to your belt.
This feature will allow you to have both hands
free when climbing a ladder or moving to an-
other work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 5).
To use clip, turn tool upside down and attach
to your belt.
2610067354 GSR18V-400 02-22.indd 11
Assembly
Do not use the power of
the drill while grasping
".
When the tool is attached
to the belt, position your-
Fig. 4
(1)
DRILL BIT
Fig. 5
-11-
CLOSE
OPEN
BIT HOLDER
SCREWDRIVER BIT
(6)
2/17/22 1:19 PM