IMPORTANT: Remove all protective plastic film from stainless
steel parts prior to assembly/use. This film is installed at the
factory to prevent damage that could occur during shipment
and handling.
Tools Required (not provided):
— 1/4" Hex Nut Driver
— Phillips Screwdriver
— Battery Powered 1/4" Hex Nut Driver
Right Side Shelf Attachment
The right side shelf attaches to the right side of the grill (Fig. 12).
1.
Secure the center of the shelf by inserting (2) self-tapping screws
2.
into the center flange underneath the shelf (Fig. 13). Use a 1/4"
hex nut driver as shown, or use a power tool whenever there is
enough room.
Secure the front of the shelf by inserting (2) self tapping screws
3.
into the front flange underneath the shelf (Fig. 14).
Secure the rear of the shelf by inserting (2) self tapping screws
4.
into the rear flange underneath the shelf (Fig. 15).
Grill Assembly — 8300 Series
Optional:
Fig. 12
Fig. 13
Fig. 14
Fig. 15
11