IMPORTANT: Remove all protective plastic film from stainless
steel parts prior to assembly/use. This film is installed at the
factory to prevent damage that could occur during shipment
and handling.
Tools Required (not provided):
— 1/4" Hex Nut Driver
— Phillips Screwdriver
— Battery Powered 1/4" Hex Nut Driver
Left Side Shelf Attachment
1.
Place a piece of styrofoam from the packaging in the grill to
leave the grill hood propped open slightly (Fig. 6).
Position the side shelf hooks with the slots on the side of the
2.
grill, near the back (Fig. 7).
Position the side shelf flange over the inside top edge of the grill
3.
(Fig. 8). Push the side shelf downward to engage the hooks and
the flange at the same time, until the top surface is level with the
grill (Fig. 9).
Secure the front of the shelf by inserting (2) self tapping screws
4.
into the front flange underneath the shelf. Use a 1/4" hex nut
driver as shown (Fig. 10), or use a power tool whenever there is
enough room.
Secure the rear of the shelf by inserting (1) self tapping screw in
5.
the back of the grill and through the shelf tab. (Fig. 11).
10
Grill Assembly — 8300 Series
Optional:
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11