Table of Contents
Advertisement
Interior Parts Installation
Insert the row of four heat tents with the triangle ridges
1.
facing up (Fig. 33).
Install the four cooking grates on the ledges provided on the grill
2.
to create your cooking surface (Fig. 34).
Place the warming shelf on the support brackets. The end
3.
support rods slip inside the slots in the support brackets (Fig. 34).
4.
Remove the label from the drip tray. Open the door and install
the drip tray by sliding it into position as shown (Fig. 35). The drip
tray is located underneath the grill, inside the storage
compartment.
Igniter Battery Installation
1.
The AA battery, spring and igniter cap must be installed before
using (Fig. 36).
Install the AA battery, negative end first.
2.
Slide the spring assembly over the battery.
3.
4.
Screw the igniter cap onto the igniter (Fig. 37).
A spark should appear at electrode tips.
If the spark does not appear:
-Check the wire connections to the electrode module.
-Check the proper assembly of a fresh AA battery.
Grill Assembly — 8200 Series
Test the Igniter:
Fig. 33
Fig. 34
Fig. 35
Fig. 36
Fig. 37
15
Advertisement
Table of Contents
