Assign Tcp/Ip Configuration By Dhcp; Selecting Internet Access Method - NETGEAR FR114P Reference Manual

Reference Manual for the Model FR114P, FR114W and FM114P Cable/DSL ProSafe Firewall
Select TCP/IP, and then click OK.
d.
If you need Client for Microsoft Networks:
Click the Add button.
a.
Select Client, and then click Add.
b.
Select Microsoft.
c.
Select Client for Microsoft Networks, and then click OK.
d.
Restart your PC for the changes to take effect.
3.

Assign TCP/IP configuration by DHCP

After the TCP/IP protocol components are installed, each PC must be assigned specific
information about itself and resources that are available on its network. The simplest way to
configure this information is to allow the PC to obtain the information from the internal DHCP
server of the NETGEAR ProSafe Firewall. To use DHCP with the recommended default
addresses, follow these steps:
Connect all PCs to the firewall, then restart the firewall and allow it to boot.
1.
On each attached PC, open the Network control panel (refer to the previous section) and select
2.
the Configuration tab.
From the components list, select TCP/IP->(your Ethernet adapter) and click Properties.
3.
In the IP Address tab, select "Obtain an IP address automatically".
4.
Select the Gateway tab.
5.
If any gateways are shown, remove them.
6.
Click OK.
7.
Restart the PC.
8.
Repeat steps 2 through 8 for each PC on your network.

Selecting Internet Access Method

On the Windows taskbar, click the Start button, point to Settings, and then click Control Panel.
1.
Double-click the Internet Options icon.
2.
3-4 Preparing Your Network