Asus PRIME Intel 500 Series Manual page 36

GPIO3 Force Pwr
Allows you to enable or disable GPIO3. Configuration options: [On] [Off]
Wait time in ms after applying Force Pwr
Allows you to set the wait time specified in milli second after Force Pwr is asserted
before access the TBT controller. Configuration options: [1] – [5000]
GPIO filter
GPIO filter is needed to avoid electrical noise on PCH GPIOs during hotplug of 12V
USB devices. Configuration options: [Disabled] [Enabled]
DTBT Controller 0 Configuration
Allows you to configure the DTBT Controller 0 Configuration options. For items without
a pop-up menu, you can either enter a number within the valid input range or use the
<+> or <-> to set the values.
DTBT Controller 0
Configuration options: [Disabled] [Enabled]
DTbt Root Port Type
Allows you to select the TBT Root Port Type.
Configuration options: [PCH Root Port] [PEG Root Port]
TBT Host Router
Allows you to enable the host router based on the ports available.
Configuration options: [One port [Two port]
Extra Bus Reserved
Configuration options: [0] – [255]
[56]
[106]
Reserved Memory
Allows you to set the reserved memory specified in MB for the Root Bridge.
Configuration options: [1] – [4096]
Memory Alignment
This item is specified in bit. Configuration options: [0] – [31]
Reserved PMemory
Allows you to set the reserved prefetchable memory specified in MB for the Root
Bridge. Configuration options: [1] – [4096]
PMemory Alignment
This item is specified in bit. Configuration options: [0] – [31]
Reserved I/O
Configuration options: [0] – [60]
Thunderbolt(TM) OS select
Windows 10 Thunderbolt support
Configuration options: [Enable + RTD3] [Disabled]
36
https://tm.by
Интернет-магазин TM.by
One port Host.
Two port Host.
PRIME / TUF GAMING Intel
®
500 Series BIOS Manual