Loading And Removing A Disc - Epson ET-18100 Series User Manual

Loading Paper, Discs, and PVC ID Cards
❏ Depending on the print area setting, the disc or disc/ID card tray may get dirty. Make settings to print on the
printable area.
❏ You can set the print range for the disc to a minimum of 18 mm for the inner diameter, and a maximum of 120
mm for the outer diameter. Depending on the settings, the disc or disc/ID card tray may be smeared. Set within
the print range for the disc you want to print.

Loading and Removing a Disc

Important:
c
❏ Before printing on the disc, see the disc handling precautions.
❏ Do not insert the disc/ID card tray while the printer is operating. This may damage the printer.
❏ Do not insert the disc/ID card tray until you send the print data and the
occurs and the tray is ejected.
1. When the output tray is ejected, check that there is no paper on the tray, and then close it by pushing it with
your hand.
2. Send print data from a computer.
b
3. When the light turns on, follow the instructions below to load the disc.
4. Remove the disc/ID card tray stored under the output tray.
5. Check that the disc/ID card tray is clean. If it is dirty, clean it using a soft, clean cloth that has been dampened
with water.
> >
Loading a Disc Loading and Removing a Disc
b
light turns on. Otherwise, an error
31