Advertisement
Tent Configuration Section
The following chart is designed to show the variety of options available for access or ventilation with the X4 Tent. By
zipping or rolling up the flaps on the Rainfly, Inner Tent, or a combination of both, you can provide access, privacy or
maximum cross ventilation to enhance the camping experience.
Rainfly Options
Awning 1
Zipped
Awning 2
Zipped
Front Door
Zipped
Back Door
Zipped
*
See following Awning Assembly instructions below.
Inner Tent Options
Side Door 1
Zipped
Side Door 2
Zipped
Front Door
Zipped
Back Door
Zipped
Inner Door
Zipped
2 Ceiling Vents
Zipped
To Assemble Right or Left Side Awning
1. Unzip the right or left side Awning Flap on Rainfly. Select which awning you prefer to use, then insert the two
furnished Awning Poles into grommets on web straps. (Detail A)
2. Tie guylines onto loops on the web straps, extend out, and secure with stakes. (Fig. 10)
Web Strap
Guyline
6
Rolled
Awning*
Rolled
Awning*
Rolled
Rolled
Rolled
Rolled
Rolled
Rolled
Rolled
Rolled
Detail A
3. Insert curved end of Gold Leg Poles into gold-colored fittings on Center Support Pole; then insert curved end of
Chrome Center Poles into chrome-colored fittings on Center Support Pole. (Fig. 3)
4. Insert bottom end of the four Gold Leg Poles into grommets on corner web straps (Detail A); then insert bottom
end of the four Chrome Center Poles into grommets on center front & back web straps (Detail B).
Gold Leg
Poles
Detail A
5. Snap both center hooks on top of tent onto middle section of the Center Support Pole. (Fig. 4 & 5)
NOTE: Unzipping Bedroom Door Panel and Living Area Door Panel will allow easier access to attaching the
center hooks of the tent to the Center Support Post.
FIG. 10
FIG. 4
Center
Support Pole
Chrome
Leg
Poles
Detail B
Bedroom
Door
Panel
Gold Leg
Poles
FIG. 3
Living Area
Door Panel
FIG. 5
3
Advertisement
