Advertisement
To prevent damage to the equipment and operating
personnel, please observe the following precautions:
Set the projector voltage switch to the proper wall outlet
voltage for your country (USA = 120v and UK = 240v).
Make sure that the voltage source contains a satisfactory
path to ground.
Do not operate the unit where fluids can come into
contact with the electrical components.
Maintain a six-inch air space around all sides of the
equipment to allow for proper ventilation.
When changing the bulb:
1. Disconnect the electrical supply.
2. Allow the unit to cool.
3. Use only a General Electric 787 (6 volt, 10 watt) lamp
or the equivalent (Navitar part #9-12126). Higher
wattage lamps will cause severe internal Damage to
the camera and electronics.
There are no user serviceable components (other than
changing the lamp). Opening the unit will expose danger-
ous voltage levels and sensitive electronic components.
A qualified technician should perform all repairs.
To prevent the unit from damaging condensation and
thermal shock, certain procedures must be followed:
1. In cold weather, always put the unit in a moisture proof
container or enclosure before transporting.
2. Either keep the unit warm during transportation, or
allow sufficient time for it to warm up at the destination.
Keep the unit in the original moisture proof package
while it warms up. (The goal is to prevent warm, moist
air from striking the cold electronic and optical compo-
nents, which will cause damaging condensation).
Never operate a cold projector to warm it up.
7
Advertisement
