Advertisement
Use a General Electric 787 (6 volt, 10 watt) lamp or its
equivalent (Navitar Part #9-12126).
1. Turn the power switch of OFF and allow the lamp to
cool before handling.
2. Loosen the cover lock screw two turns. Rotate the
cover counterclockwise and remove.
3. Remove the old lamp by pulling it straight up. Do not
twist the lamp or the glass envelope may shatter.
4. Insert the new lamp carefully.
5. Remove any fingerprints from the lamp envelope.
6. Replace the cover and tighten the lock screw.
Always switch off the projector and unplug the
mains lead before replacing a fuse!
To avoid the risk of fire, replace only with a fuse of
the same type and rating.
The electric circuit fuses, proceed as follows:
1. Pull out the fuse link compartment by gripping the
small catch.
2. Replace the defective fuse.
3. Push the fuse link compartment back into the projec-
tor. Do not change the position of the fuse holder
when reinserting it into the projector.
16
Advertisement
