Coleman Tent 9278-600 Instructions

When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
position the end of tent into the wind.
1 Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door facing
desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners, using the tent stake
loops. Keep the floor taut. (illus. 2)
– Assemble all poles by interlocking shock-
corded poles.
– Insert the black poles into center pole sleeves
marked with black binding.
The poles should cross forming an
"X" in the middle of tent. (illus. 1)
Front door
Montana Big Sky
Instructions apply to Part Number 9278-600
(2) Main Tent Poles
(2) Side Tent
Poles (Grey)
(2) Rainfly Poles
Hinged Door Pole
Vertical Hinged Door Pole
Rainfly Part No.
9278-1091
Black poles
illus. 1
illus. 2
Tent
stake through
stake loop
POLE ASSEMBLY PARTS
Part No. 9278B3681
(Black)
Part No. 9278B3691
Part No. 9278B3651
Part No. 9278-1101
Part No. 9278-1111
2 Connect Frame to Tent
– Locate the pin & ring systems on either side of
the front door and the corresponding pin & rings
on the back side of tent.
– Insert one end of black frame pole onto pin &
ring system on tent stake loop on either side of
front door. (illus. 3)
– Go to opposite end of pole diagonally from
starting point and gradually apply pressure to the
pole forming an arch until you are able to insert
the pin into pole end.
– Repeat for second pole.
– Attach tent frame clips to poles.
Elite 16'x7'
™
Center section upright
illus. 3
pin & ring system located
on the front & rear of tent
Black poles
illus. 4