Answering System Settings - Panasonic KX-TG4222C Operating Instructions Manual

Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts, enter
your remote access code.
3
Follow the voice guidance prompts as
necessary or control the unit using
remote commands (page 25).
4
When finished, hang up.
Voice guidance
During remote operation, the unit's voice
guidance starts and prompts you to press 1
to perform a specific operation, or press 2 to
listen to more available operations.
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your call.
Remote commands
You can press dial keys to access certain
answering system functions without waiting for
the voice guidance to prompt you.
Key Operation
1 Repeat message (during
*1
playback)
2 Skip message (during playback)
4 Play new messages
5 Play all messages
9 Stop playback
0 Turn answering system off
*4 Erase currently playing message
*5 Erase all messages
*# End remote operation
(or hang up)
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
TG422xC(en)_0122_ver011.pdf
Turning on the answering system
remotely
If the answering system is off, you can turn it
on remotely.
1
2
3

Answering system settings

Number of rings before the unit
answers a call
You can change the number of times the
phone rings "Ring count" before the unit
answers calls. You can select 2 to 7 rings, or
"Toll saver".
The default setting is "4 rings".
"Toll saver": The unit's answering system
answers at the end of the 2nd ring when new
messages have been recorded, or at the end
of the 5th ring when there are no new
messages. If you call your phone from outside
to listen to new messages (page 24), you
know that there are no new messages when
the phone rings for the 3rd time. You can then
hang up without being charged for the call.
1
2
3
4
5
25
Answering System
Dial your phone number from a
touch-tone phone.
Let the phone ring 15 times.
R A long beep is heard.
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your
remote access code again and begin
remote operation (page 24).
MMENUN
MbN: "Answering device" a MOKN
MbN: "Settings" a MOKN
MbN: "Ring count" a MOKN
MbN: Select the desired setting. a MOKN
a MOFFN
2013/01/22 11:22:41
25