Advertisement
6.1. Using back plate as template.
6.2. Making sure UP arrow points UP.
6.3. Mark and drill holes.
6.4. Insert wall plugs and attach to wall using screws provided.
6.5. Clip the Bell Push on to the back plate making sure the Bell Push 'Clicks' in to place.
6.6. Plug the Door Chime into a socket, within the operating range (50M). Transmission of the wire free signal through walls, doors and ceilings etc, may reduce the operating range.
7.1: Remove back plate from the Bell Push
7.2: Remove old battery from the holder
7.3: Replace with new '23A' battery
7.4: Insert the 23A battery into the battery holder, making sure the Positive/Negative terminals match the internal markings.
7.5: Test Chime Kit
ATTENTION:
Avoid positioning the Bell Push/Chime on or directly near metallic surfaces as this may reduce the operation range.
UPVC Door Frames:
When positioning the bell push onto a UPVC door, always check the operating performance before final installation, internal metal frame of the door may affect performance.
Tip: Try adjusting the location of the Bell Push slightly to the Left/Right or place on an external wall.
Note: the appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction. Children should be supervised to ensure that they do not play with the appliance.
In case of the door chime does not sound, please check the followings:
Type R2 Device - device where the sound output is created by the initial operation of the control and where the period of sound output continues for the designed duration irrespective of condition of the control.
There are no serviceable parts, do not repair. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Children should be supervised to ensure that they do not play with the appliance.
Bell Push: 90017
Power: 1 x 23A 12V DC Battery (Included)
IP44 Weather Resistant
Plug in door chime: DB421E-F
Power: 230 - 240V 50Hz
Max Load: 3000W
Range: 50 Meter
Indoor Use Only
This symbol is known as the 'Crossed-out Wheelie Bin Symbol'. When this symbol is marked on a product or battery, it means that it should not be disposed of with your general household waste. Some chemicals contained within electrical/electronic products or batteries can be harmful to health and the environment. Only dispose of electrical/electronic/battery items in separate collection schemes, which cater for the recovery and recycling of materials contained within. Your co-operation is vital to ensure the success of these schemes and for the protection of the environment
Smartwares Safety & Lighting
Byron House, 34, Sherwood Rd,
Aston Fields, Bromsgrove, B60 3DR - UK
www.chbyron.eu/byronsupport
Tel: 0345 2301231 (UK)
10-4 Mon-Fri, except Thurs 12:30-4
Local call charges apply
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Byron DB421E-F - Wirefree Plug-through Door Chime Kit Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the DB421E-F that isn't answered in the manual? Leave your question here.