Advertisement
Quick Links
™
DB304
1
2
Using a small flat
Insert the 23A battery
screwdriver, insert into the
(supplied) into the battery
locking clip and gently
holder, making sure the
twist. The back plate will
Positive/Negative terminals
unclip from the Bell Push.
match the internal
markings. Battery Comes
Preinstalled
4
5
Press the learn button (L)
Press the Bell Push within
30 seconds, the Chime
on the back of the Chime
to enter the Learn mode.
will ring to confirm that
The chime will ring to
the Bell Push has been
confirm.
paired to the Chime.
Tel: 0845 2301231
9-5 Mon-Fri, Local call charges apply
support@chbyron.com
www.chbyron.com
75Metres
Wire Free Chime Kit
3
Remove the battery cover and
insert 3 X 1.5V Size 'AA'/LR6
batteries (not supplied), making
sure the Positive/Negative
terminals match the internal
markings. Chime will ring
when batteries are inserted.
6
Test the Chime in the intended
location, as internal walls and
surfaces may reduce operating
range. DO NOT mount onto
metallic surfaces.
CH Byron
(UK)
Byron House, Sherwood Rd
Astonfields, Bromsgrove
B60 3DR
UK
Usage Guide:
Avoid positioning the Bell Push/Chime on or directly near
metallic surfaces as this may reduce the operation range.
UPVC Door Frames:
When positioning the bell push onto a UPVC door, always check the
operating performance before final installation, internal metal frame of
the door may affect performance.
Tip: Try adjusting the location of the Bell Push slightly to the Left/Right or place on
external wall.
Note: the appliance is not to be used by children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge,unless they have
been given supervision or instruction. Children should be supervised to ensure that
they do not play with the appliance.
Bell Push & Door Chime:
1: Using back plate as template
2: Making sure UP arrow points UP.
3: Mark and drill holes.
4: Insert wall plugs and attach to wall using screws
provided.
5: Clip the Bell Push on to the back plate making sure
Bell Push 'Clicks' into place.
6: Place the Door Chime within the operating range (75M).
Transmission of the wire free signal through Walls, Doors
and Ceilings etc, may reduce the operating range.
The Chime is designed for INDOOR use only.
Melody
Selection:
To select a new melody for the Door Chime
1:Press the Melody Select button (M) on the
back of the Chime unit.
2:The Chime will play the newly selected
melody.
3:Press again to select the next melody.
Specification
Bell Push: DBT-SL
Power: 1 x 23A 12V DC Battery (supplied)
IP44 Weather Resistant
Resetting
Chime:
To reset the chime and delete the bell push
learnt to the chime
1:Press and hold the Learn button (L) until
the Chime plays a melody - approximately
6 seconds.
2:The Chime has been reset
- see Points 4&5 to pair Bell Push
Portable Door Chime: DB304
Power: 3 x AA/LR6 1.5V Batteries (Not supplied)
Range: 75 Metres
Indoor Use Only
R&TTE
V1.1
APPROVED
Project Manager:Mr G Hunter
Advertisement
