Connecting The Power Cord - H3C S6825 Series Installation Manual

Figure2-29 Removing the power cord from the power supply
3. Hold the handle of the power supply with one hand, press the latch on the power supply
towards the handle direction with your thumb, and pull the power supply part way out of the slot.
Supporting the power supply bottom with the other, slowly pull the power supply out of the slot
along the guide rails.
4. Put the removed power supply in an antistatic bag for future use.
Removing a PSR450-12D DC power supply
The following procedure removes a PSR450-12D power supply.
To remove a PSR450-12D power supply:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Use a flat-head screwdriver to loosen the screws on the power cord connector, and then pull the
connector out to remove the power cord. See Figure2-30.
3. Hold the handle of the power supply with one hand, press the latch on the power supply
towards the handle direction with your thumb, and pull the power supply part way out of the slot.
Supporting the power supply bottom with the other, slowly pull the power supply out of the slot
along the guide rails. See Figure2-27.
4. Put the removed power supply in an antistatic bag.
Figure2-30 Removing a PSR450-12D power supply
(1) Use a flat-head screwdriver to loosen the screws on the power cord connector
(2) Pull the power cord connector out

Connecting the power cord

WARNING!
Provide a circuit breaker for each power input. When you connect a power cord, make sure the
circuit breaker is switched off.
2-22