Tilt Drive; Rotation Drive; Longitudinal Table Drive; Spotfilm Device - Siemens UROSKOP D Additional Installation, Operation And Maintenance Instructions

2 - 10
2.5.2

Tilt drive

PMP Linear bearing
•
Lightly grease the linear bearings with LONGTIME PD2.
PMP Bearing track of the tilt function
•
Lightly grease the bearing track with LONGTIME PD2.
PMP Tilt spindle
•
Lightly grease the tilt spindle with LONGTIME PD2.
PMP Ball bearing guides
•
Lightly grease the ball bearing guides with LONGTIME PD2.
PMP Toothed gears
•
Lightly grease the toothed gears of the potentiometer drive (r103), with LONGTIME PD2.
2.5.3

Rotation drive

PMP Spindle (Uroskop D2/D3 only)
•
Grease the rotation drive spindle with LONGTIME PD2.
2.5.4

Longitudinal table drive

PMP Rails
•
Clean the guide rails and lightly grease them with silicon paste.
2.5.5

Spotfilm device

PMP Cleaning
•
Clean the entire spotfilm device inside, where accessible.
2.5.6

System general

PMP Contrast agent residues
•
Remove any contrast agent residues and other contamination from points on the system
normally not accessible to the customer.
PMP Cables and hoses
•
Clean all accessible cables and hoses.
UROSKOP D
Inspection and maintenance
RLL5-310.101.02 Page 10 of 16
Rev. 02 01.97 TDSP 1
Siemens AG
Medical Engineering