Configuring Ifr 2968 Setup - Motorola ST7000 Basic Service Manual

MN002952A01-AH
Chapter 4: Test Setup and Testing
Short Subscriber Identity (SSI): (use fixed) 9999
Group Short Subscriber Identity (GSSI): (use fixed) 1001
Power Class: (use fixed) 4 (30.0dBm/1W)
Receiver Class: (use fixed) A
NOTICE: The number for Short Subscriber Identity (SSI) and Group Short Subscriber
Identity (GSSI) is based on the number key in the Codeplug of the radio.
12 Press Config → Config → Configure. Select Call Types.
13 Enter the following parameters:
Priority: 00 = Priority Not Defined
Calling Party SSI: 100
14 Press Config → Config → Configure. Select Call Timers & Trunking.
15 Enter the following parameters:
Trunking Type: Transmission
Simplex Traffic Channel Type: DL and UL TCH
Test Set Transmit Mode: Continuous
16 Leave the rest of the parameters in their default values.
17 Press Config → Config → Configure. Select Neighbour Cell Info.
18 Enter the following parameters:
Broadcast: Not supported
Broadcast Interval: 5 s
Neighbour Cell Channel: 3500
Neighbour Cell Location Area: 1
Neighbour Cell Identifier: 1
Slow Re-select Threshold Above Fast: 10 dB
Fast Re-select Threshold: 10 dB
Slow Re-select Hysteresis: 10 dB
Fast Re-select Hysteresis: 10 dB
19 Press Config → Config → Configure. Select Base Service.
20 Use the following default parameters:
POWER ON REGISTRATION: REQUIRED
POWER OFF DE-REGISTRATION: REQUIRED
PRIORITY CELL: YES
MINIMUM MODE SERVICE: NEVER USED
MIGRATION: SUPPORTED
SYSTEM WIDE SERVICE: NORMAL MODE
TETRA VOICE SERVICE: SUPPORTED
CIRCUIT MODE DATA SERVICE: NOT SUPPORTED
(RESERVED): NOT AVAILABLE
TETRA PACKET DATA SERVICE: NOT AVAILABLE
AIR INTERFACE ENCRYPTION: NOT AVAILABLE
ADVANCED LINK: NOT SUPPORTED
NOTICE: Store these settings in the IFR to be recalled for future use.
4.6

Configuring IFR 2968 Setup

Use these procedures to configure the IFR 2968 setup.
Procedure:
1 Turn ON the IFR.
46