Table of Contents
Advertisement
Terminal Panel Features
1
P C
C O
N T
R O
L
1. PC Control Port (Mini DIN 8 Pin)
Use this port to connect your PC to control your projector via a
serial cable. This enables you to use your PC and serial com-
munication protocol to control the projector. The NEC optional
serial cable is required to use this port.
If you are writing your own program, typical PC control codes
are on page E-42.
A cap is put on the port at the factory. Remove the cap when
using the port.
2. Audio Input Mini Jack (3.5 mm
This is where you connect audio output from your computer,
VCR, DVD player or laser disc player.
A commercially available audio cable is required.
3. Video Input (RCA)
Connect a VCR, DVD player, laser disc player, or document
camera here to project video.
4. S-Video Input (Mini DIN 4 Pin)
Here is where you connect the S-Video input from an external
source like a VCR.
NOTE: S-Video provides more vivid color and higher resolution than
the traditional composite video format.
5. RGB Input/Component Input Connector
(Mini D-Sub 15 pin)
Connect your PC or other RGB equipment such as IBM or
compatible computers. Use the supplied RGB cable to con-
nect to a PC. Or connect a Macintosh computer here using the
supplied RGB cable. This also serves as a component input
connector that allows you to connect a component video out-
put of component equipment such as a DVD player.
2
3
4
A U
D I O
V I D
E O
S - V
I D E
O
)
5
R G
B
A C
I N
6
6. AC Input
Connect the supplied power cable's three-pin plug here. When
you plug the other end into an active wall outlet, the POWER
indicator turns orange and the projector is in standby mode.
7. Built-in Security Slot (
This security slot supports the MicroSaver® Security System.
MicroSaver® is a registered trademark of Kensington
Microware Inc.
The logo is trademarked and owned by Kensington Microware
Inc.
E-11
7
)
Advertisement
Table of Contents
