Hvac Selection - Radio Thermostat CT32 Install Manual

HVAC Selection

• Set the HVAC TYPE switch in the NORM position if you have normal natural gas,
propane, oil, or electric heat. If you have a HEAT PUMP system set the HVAC
TYPE switch to HP. They are located under the top cover on the left.
• Set the HEAT TYPE switch in the GAS position if you have normal gas or oil heat
or if you have a heat pump with gas or oil auxiliary heat. Put the HEAT TYPE in
the ELEC position if you have normal electric heat or if you have a heat pump with
electric auxiliary heat.
Install 4 AA Batteries
• Install 4 AA alkaline batteries [required] following the
marked polarity in the battery compartments. Put the battery
in negative end first against the spring, then push the
positive end in.
IMPORTANT: Press the RESET button (under top cover)
to implement the HVAC switch selections.
• With all the wires connected it is time to turn the AC power
back on. Do this at the breaker you used to switch it off. The CT32 will power-up in the OFF mode. Your CT32 is
not configured to operate your HVAC system yet. You must now configure your thermostat for your HVAC
system.
8
PG
HE AT TYP E
HV AC
GA S or
TYP E
ELE C