Table of Contents
Advertisement
LEVELLING OF THE APPLIANCE
Use small feet on the bottom of appliance to set the
appliance top surface level with other surfaces.
ANTI-TILT PROTECTION
Adjust the appliance to the correct height and put it
in the correct area before you attach the anti-tilt
protection.
CAUTION! Install the anti-tilt
protection to prevent the appliance
from falling under incorrect loads. The
anti-tilt protection only works when the
appliance is put in a correct area.
The anti-tilt protection has two parts (A + B). You
can find the anti-tilt protection (B) on the right or
left side of the rear wall of the appliance.
1. Install the anti-tilt protection (A) on the wall.
Make sure that the wall is made of a solid
material. If not, you need to make the wall
sufficiently strong to hold the weight.
Make sure that the surface behind the
appliance is smooth.
2. Put the appliance in the middle of the space
between the cupboards.
If the space is larger than the width of the
appliance, you must adjust the side
measurement.
3. Install the anti-tilt protection (A) approximately
77 mm below the top surface of the appliance
and 50 mm from the left or right side of the
appliance into the circular hole on the bracket.
Screw it into the wall.
4. Check that the anti-tilt protection (A) fits
ELECTRICAL INSTALLATION
This appliance is supplied without a main plug or a
main cable.
COVERING TERMINAL BOARD
B
•
•
•
TERMINAL BOARD
Make sure that the links are fitted as shown.
minimum 20 mm into the hole in the rear wall of
the appliance (B) when you push the appliance.
WARNING! The manufacturer is not
responsible if you do not follow the
safety precautions from Safety
chapters.
The recommended cross-section area is six
square millimetres (6 mm²).
When you refit the mains terminal cover, make
sure that the lower tabs are located inside the
bottom edge of the aperture, before you fix the
two screws into the top edge of the mains
terminal cover.
Make sure that the cover is securely fastened.
To open the cover of terminal board
obey the procedure in opposite
sequence.
Do not remove blanking plates.
50 mm
77 mm
A
21
Advertisement
Table of Contents
