APRILIA RS 125 Euro 4 Service Manual page 90

Electrical system
TABLE F - PRE-FITTING OF RADIATOR FAN
1. Radiator fan.
G TABLES - PRE-FITTING OF ABS - PROCE-
DURE FOR INSERTION OF ABS CONNECTOR
TABLE G1
1. ABS Modulator.
2. ABS modulator support.
3. Fastener screw.
Using the special screw, place the ABS modulator
on the support
TABLE G2 - PROCEDURE FOR INSERTION OF ABS CONNECTOR
The position of the connector fastener lever must be as shown in Figures "1" and "2".
Place the connector on the opposite side of the control unit and lower the driving lever until the "click"
that signals the end of the stroke is heard as in Figure "3".
TABLE G3
ELE SYS - 90
RS 125 - Tuono 125 - Euro 4