APRILIA RS 125 Euro 4 Service Manual page 78

Electrical system
•
2 turn indicator wiring harnesses
•
1 H.V. cable
•
1 blinker
•
1 start-up relay 12V 80A
•
3 relays 12V 30A
Small parts and mountings:
•
7 large black 290x4.5 (11.42x0.18 in) clamps
•
6 medium black 190x4.5 (7.48x0.18 in) clamps
•
5 small black 160x2.5 (6.30x0.10 in) clamps
•
1 clamp
•
6 rubber clamps
•
1 edge clamp
•
2 cable guides
•
2 White adhesive wire holders
•
3 cable guides
•
1 circlip
•
3 retaining clips
•
1 M6x8 SHC screw
•
1 spring washer
Special checks for the correct connection and routing of cables
It is extremely important that any security-locks for the following connectors are properly connected and
correctly tightened to ensure proper engine, and therefore proper vehicle, operation. The operator must
also mark these connectors with an indelible pen.
•
Sponge connector on licence plate holder light.
•
Check the control unit connection and that the relative rubber plug is correctly inserted.
•
Check that the metallic bracket screw is correctly fastened on the throttle body .
•
Check the injector connection.
•
Check the water temperature sensor connection.
•
Check the injector and water temperature sensor cable clamp.
•
Check that the H.V. cable with coil is correctly inserted.
•
Check the coil connection and that the coil ground eyelet is correctly fastened.
•
Check that the engine oil cap is correctly inserted.
•
Check the ground fastening on the starter motor, starter motor positive and relative hood.
•
Check the NEUTRAL cable fastening. (with transparent insulating washer)
•
Check the fuel reserve sensor.
•
Check the fuel pump connection.
•
Check the regulator connection.
ELE SYS - 78
RS 125 - Tuono 125 - Euro 4