Installing The Unit - Kenwood DMX7722DABS Instruction Manual

Installation and Connection Installation and Connection
Parts list for installation
Note: This parts list does not include all the package
contents.
¥ Wiring harness (× 1)
ø Extension wire, 2 m (× 1)
π Microphone, 3 m (× 1)
[ Trim plate (× 1)
" Mounting sleeve (× 1)
] Extraction keys (× 2)
' GPS aerial, 3.5 m (× 1)
\ Metal plate (× 1)
Installation procedure
1
Remove the key from the ignition and
·
disconnect the battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector B on the wiring harness
and connect it to the speaker connector in
your vehicle.
5
Take Connector A on the wiring harness
and connect it to the external power
connector in your vehicle.
6
Connect the wiring harness to the unit.
7
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (eg., the
sound may skip).
8
·
Reconnect the battery.
9
Initialise the unit (page 44).
10
Configure <Initial Setup> (page 4).

Installing the unit

Installing the unit using the mounting
sleeve
"
Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
Installing the trim plate
[
49
ENGLISH