Table of Contents
Advertisement
CAUTION
Figure 7-1. Memory Card Battery Date Code Location
Procedure to change the memory card battery
The battery is located beside the card's write-protect switch on the
end opposite the connector.
The battery power enables the memory card's memory to retain data.
You can lose the data when the battery is removed. Replace the
battery while the card is installed in a powered-up instrument.
1. Locate the groove along the edge of the battery clip. Refer to
Figure 7-2.
2. Gently pry the battery clip out of the card. The battery ts within
this clip.
3. Replace the battery, making sure the plus (+) sign on the battery is
on the same side as the plus (+) sign on the clip.
4. Insert the battery clip into the memory card, holding the clip as
oriented in Figure 7-2. (Face the \open" edge of the clip toward
the write-protect switch on the memory card.)
5. Write the date that the battery was replaced on the memory card
label. This will help you to remember when the battery should be
replaced.
Figure 7-2. Memory Card Battery Replacement
Customer Support 7-3
Advertisement
Table of Contents
