Troubleshooting; Technical Data - Flymo Minitrim ST Operation Instructions Manual

6. TROUBLESHOOTING

Danger!
Cut injury when the product starts
accidentally.
v Before you troubleshoot the product, make sure
that the mains cable is disconnected.
Problem
Filament is to short or trimmer
vibrates
Continuous clattering noise
Filament snaps continuously
Poor performance
For any other malfunctions please contact the Husqvarna UK Ltd. Customer Service.
Repairs must only be done by Husqvarna UK Ltd. service departments or specialist dealers
approved by FLYMO.

7. TECHNICAL DATA

Turbotrimmer
Motor power consumption
Mains voltage
Mains frequency
Cutting filament thickness
Cutting width
Cutting filament supply
Cutting filament feed
Speed of cutting filament
Weight
41021-85.960.01.indd 7 41021-85.960.01.indd 7
Risk of physical injury!
Possible Causes
Filament not fed out and visible.
Filament not removed from the cleat.
Filament is jammed on the filament
cassette.
Filament is broken inside the filament
cassette.
Motor has not reached full speed
before use.
Too much filament has been fed out.
Filament limiter is missing.
You do not use the correct working
position.
Filament is jammed on the filament
cassette.
The cassette holder is dirty.
Unit Value (MST21)
W 230
V 230
Hz 50
mm 1.5
cm 21
m 5
Manual filament feed system
rpm 12,000
kg 2.0
Remedy
v Pull the filament until it reaches the
filament limiter
v Remove the filament from the cleat.
v Rewind the filament to remove
crossed loops. Check that the fila-
ment is neatly winded. If it does not
help change the filament cassette.
v Replace the cutting filament.
v Allow the motor to reach full speed
before use.
v Rewind the filament.
v Contact your local approved
Service Center or Husqvarna UK Ltd.
Customer Service.
v Use the correct working position.
v Rewind the filament to remove
crossed loops. Check that the fila-
ment is neatly winded. If it does not
help change the filament cassette.
v Clean the cassette holder.
7
20.09.21 11:37 20.09.21 11:37