Table of Contents
Advertisement
Access Control Functions
Wiegand output
The XCI-NPR has a Wiegand output which sends an identifier
of the licence plate.
The string of the licence plate detected is converted into a
number which is sent in wiegand protocol, 26 or 37 bits.
~35 µS pulse
Dirty / damaged licence plates notification
In order to avoid blind decisions, the camera is able to make
three kind of decision:
Decision to give the correct licence plate when the
-
score is reliable enough
Decision to give a fixed identifier when the score is not
-
reliable enough
Decision not to give any result for the other cases
-
This identifier used to notify dirty or damaged licence plate is
easily programmable
RS-232 output
The XCI-NPR has an RS-232 output sending a raw string of
the licence plate.
Score function for installation purpose
For installation purpose, a score function is available using a
command prompt.
This score function provides a score of the recognition of the
licence plate.
This score is between 0 and 10000.
The values displayed on the score function are the ones
returned by the recognition. If no car is recognized, no score
will be displayed.
Refer to the section "Verification of the installation" for further
information.
Flood mode
The flood function makes the camera taking a decision of the
detected licence plate each time it can (about 3 per second).
When this function is disabled, the camera will make only one
decision per licence plate detected.
CCTV Functions
Programmable Dry-Contacts
The XCI-NPR has 2 embedded programmable dry contacts.
Theses outputs can be used for various purpose like alarm
control, light control, gate control or CCTV camera control.
This enables the camera to be the heart of a full standalone
Access Control Reader + CCTV system control.
Theses Dry-Contact can be programmed as follow:
Duration
-
Always ON
-
Always OFF
-
ON when a reliable licence plate is detected
-
ON when a dirty / damaged licence plate is detected
-
JPEG & String of the licence plate on TCP/IP
A picture of the licence plate is available on a specific socket
on the Ethernet output. An SDK is available, quick and easy
to integrate.
Moreover, the string of the licence plate is also available
within the same structure.
General Functions
Scheduler
The camera has a built-in scheduler function accessible via
the web interface. This scheduler allows the camera to be set
into a sleeping mode for the programmed hours in order to
decrease the power consumption of the camera during
unused moments.
Functions
Page 13 / 42
Advertisement
Table of Contents
