Table of Contents
Advertisement
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN ANY INTERNAL DEVICE AND CABINET INSIDE THE HOUSING OF THE CAMERA.
REFER SERVICICE TO QUALIFIED PERSONNEL ONLY.
CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD
VOID THE USERS'S AUTHORITY TO OPERATE THE EQUIPMENT.
CAUTION: USE THE POWER SOURCE DESCRIBED IN THIS MANUAL.
CAUTION: FOR SAFETY REASONS DO NOT CONNECT THE CONNECTOR FOR PERIPHERAL DEVICE WIRING THAT MIGHT HAVE
EXCESSIVE VOLTAGE TO THIS PORT. FOLLOW THE INSTRUCTIONS FOR THIS PORT.
This mark applies in
EU countries only
WARNING
This unit has no power switch.
When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, or connect the power cord to socket-outlet which
must be provided near the unit and easily accessible.
If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the power cord.
CE COMPLIANCE STATEMENT
WARNING: THIS IS A CLASS A PRODUCT. IN A DOMESTIC ENVIRONMENT THIS PRODUCT MAY CAUSE RADIO INTERFERENCE IN
WHICH CASE THE USER MAY BE REQUIRED TO TAKE ADEQUATE MEASURES.
CAUTION: BEFORE ATTEMPTING TO CONNECT OR OPERATE THIS PRODUCT, PLEASE READ THE LABEL ON THE BOTTOM AND USER'S
MANUAL CAREFULLY.
CAUTION FOR LAN PORT: FOR SAFETY REASON, DO NOT CONNECT THE LAN PORT TO ANY NETWORK DEVICES THAT MIGHT HAVE
EXCESSIVE VOLTAGE.
CAUTION: DURING THE PRODUCT INSTALLATION, A DEVICE OUTAGE MUST BE USED.
CAUTION: FUSE ON THE ELECTRICAL INSTALLATION MUST BE 16A OR LESS.
CAUTION: AN OVERCURRENT PROTECTION DEVICE SHOULD BE USED TO AVOID DAMAGE RISK FOR THE PRODUCT.
REMARKS
This camera is a non branded product.
It is the customer's responsibility to brand the product and make the related declaration of CE conformity.
In order to comply with the legislation in force (in 2008), the customer has to take the following actions regarding the product:
-
Labelling must me made on the product, including the name of the supplier and the serial number
-
Safety instructions must be written in the language of the country where the product is installed
If needed, ask your supplier for EMC and LVD test report for confirmation about the CE conformity of the product.
Note
Before using the camera, please read carefully the Operating Instructions document.
Page 2 / 42
Advertisement
Table of Contents
