Table of Contents
Advertisement
event. A network management system (NMS) is needed to
get information from SNMP capable devices.
• SNMP Mode: enabling this function (on) will put SNMP
agent on. SNMP is used to send maintenance requests to
the camera.
• Trap destination, community, Location, Contact: these
fields enables user to configure the SNMP settings of the
camera.
NTP
• Mode: if this function is enabled then the camera will use
NTP protocol to synchronize its clock with all network
devices.
• Timezone, Timeout, Sync interval, NTP Sever: these fields
enables user to configure the NTP settings of the camera.
Note : A message "unlinked" could occur if the page needs
to be refresh. This doesn't required any particular attention
but one can clear it by refreshing the web page.
Page 31 / 42
Advertisement
Table of Contents
