Factory Default (Menu => Setup => Factory Default); Erase Data (Menu => Setup => Erase Data); System Information (Menu => Setup => System Informaion) - Honeywell ScanDome III HSDC-252 Series Operation & Programming Manual

AUTO CALIBRATION : The dome camera calibrates automatically when the
3.5.7 FACTORY DEFAULT (MENU => SETUP => FACTORY DEFAULT)
Programmed data go back to initial state as ex-factory
3.5.8 ERASE DATA (MENU => SETUP => ERASE DATA)
Erase programmed data in the EEPROM of the selected dome camera. Press MENU or ENTER
button to erase data, ESC key to exit without erasing. Origin offset value is not affected.
CAUTION: Unless you download the data into a safe place, all the data in the selected dome
camera will be lost. (Refer to Download/ Upload data function in the Keyboard
Configuration utility)
3.5.9 SYSTEM INFORMATION
(MENU => SETUP => SYSTEM INFORMAION)
This screen shows information of the dome camera for service or trouble shooting
deviation of dome position by force or vibration is detected.
( over 2 degrees )
Factory Default
Are You Sure : (Y/N)
Yes : ENTER OR MENU KEY
No : ESC KEY
Erase Programmed Data
Are You Sure : (Y/N)
Yes : ENTER OR MENU KEY
No : ESC KEY
System Information
Camera Type : XXXXXXX
H/W Version : V1.0
ROM Version : V1.0
Protocol : S2E
Baudrate : 9600bps
Exit
35