3
|
Components
To install the swing flap motor
3.13 Thermistors
3.13.1 Refrigerant side thermistors
Checking procedures
To perform a mechanical check of the specific thermistor
Service manual
108
2 Disconnect the connector from the swing flap motor.
3 Remove the screw from the swing flap motor.
4 Remove the swing flap motor from the swing flap.
5 To install the swing flap motor, see
1 Install the swing flap motor in the correct location on the swing flap.
a
a Cover
b Screw
c Swing flap motor
2 Install and tighten the screw to fix the swing flap motor.
3 Connect the connector to the swing flap motor.
4 Install the cover.
Is the problem solved?
Yes
No
INFORMATION
It is recommended to perform the checks in the listed order.
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Locate the thermistor and remove the insulation if needed. Check that the
thermistor is correctly installed and that there is thermal contact between the
thermistor and the piping or ambient (for air thermistor).
"3.12.2 Repair
procedures" [
b c
Action
No further actions required.
Return to the troubleshooting of the
specific error and continue with the
next procedure.
"3.10 Plate
work" [
RXQ25+35AMV1B + ARXQ25+35AMV1B + FTXQ25+35AMV1B +
4
107].
4
94].
ATXQ25+35AMV1B
Split Sensira R32 BBOP
ESIE21-16 – 2022.02