Table of Contents
Advertisement
Power-On Test
Test the modem by turning it on (a power switch is located on the
front panel). When you turn it on, the modem performs a diagnostic
self-test, indicated by the TM indicator lighting for a few seconds,
after which the LCD should light. If this does not happen, check that
the power switch is on, the transformer module supply is solidly
connected, and the AC outlet is live.
Step 2: Install the Modem Driver
If you use Windows 98/Me/NT/2000/XP, you must install the modem
driver. When operating the modem under Windows, the modem driver
can be installed by using the Plug-and-Play feature. If you use an
operating system that does not support Plug-and-Play, see the User
Guide.
Modem Driver Installation for Windows 98/Me/2000/XP
1. Make sure your modem is connected properly, and then turn on
your computer. Windows should detect your new modem and
open the Install New Modem wizard.
Note: If Windows cannot find a modem, see the
"Troubleshooting" chapter of the User Guide.
For Windows NT, the Install New Modem wizard presents one
additional prompt before Step 2. At this prompt, select Don't
detect my modem, I will select it from a list. Then click Next. A
dialog box with a list of manufacturers and a list of modem
models appear. Select your modem.
2. Insert the MultiModemII CD into your CD-ROM drive. Click OK.
3. Windows installs and configures the modem.
4. Click Finish to exit.
MultiModemII Quick Start Guide
3
Advertisement
Table of Contents
