How To Set Jumpers - Multitech IPC-623C User Manual

2-3 How to Set Jumpers

You can configure your board by setting the jumpers. Jumper
consists of two or three metal pins with a plastic base mounted
on the card, and by using a small plastic "cap", Also known as
the jumper cap (with a metal contact inside), you are able to
connect the pins. So you can set-up your hardware
configuration by "opening" or "closing" the pins.
The jumper can be combined into sets called jumper blocks.
When the jumpers are all in the block, you have to put them
together to set up the hardware configuration. The figure below
shows what this looks like.
JUMPERS AND CAPS
2 Pin Jumper
If a jumper has three pins (for example, labelled PIN1, PIN2,
and PIN3), You can connect PIN1 & PIN2 to create one setting
and shorting. You can connect PIN2 & PIN3 to create another
setting. The same jumper diagrams are applied all through this
manual. The figures on the next page will show you what the
manual diagrams look like and what they represent.
CommPlete 4000 Server SBC, Model IPC-623C
3 Pin Jumper
Hardware Configuration
Jumper Block
Jumper Cap
13