Basic Operation
The following procedures describe how to operate basic functions of the Automate VX system.
For information on how to enter the web user interface, refer to
Interface on page
68.
When the web user interface is opened, there are five main tabs that control the operation of
the Automate VX system. The contents of these tabs are explained below.
NOTE: Before using these controls, ensure that the Automate VX system is configured to the
desired specifications. For more information on how to configure the Automate VX, refer to
System Configuration on page 68
Main Menu
Select the Main tab to view and perform common functions for the Automate VX system.
Main Menu Selections
Select AutoSwitch to start and stop automated switching. AutoSwitching is the Automate
VX system using the Virtual Mic positions from Room Designer in conjunction with the
Microphone Device to switch camera shots automatically. The software only communicates with
Microphone Devices when AutoSwitch is activated. For more information on setting up a room
layout in Room Designer to ensure the best AutoSwitching performance, refer to the
Designer on page 26
section.
91 • IV-SAM-VXN-1B, IV-SAM-VXP-1B, and IV-SAM-VXS-1B
and
Room Designer on page
Access the Web Configuration
26.
Room
Product Manual — Doc. 9324C