ActionTec ScreenBeam Mini 2 SBWD60A User Manual page 23

Wireless display receiver
Hide thumbs Also See for ScreenBeam Mini 2 SBWD60A:
Table of Contents

Advertisement

NVIDIA Shield does not see my ScreenBeam Mini 2 Receiver, or it sees the
Receiver as "unavailable" or "busy" even after a rescan.
Exit out of the NVIDIA's Miracast settings window and go back.
My Windows 8.1 displays to the TV but the four edges are cut off (overscan).
This is expected with some system's supported display resolution. You can adjust Windows
screen resolution settings to fit the computer's screen on your TV display.
When I connect to an access point or wireless router with an active WiDi
session, the WiDi connection drops.
This is a known issue with Intel WiDi, and happens with either 3.5.41.0 or 4.0.1.8 on both
Windows 7 and 8. Re-connect the WiDi session or connect to the AP first before starting a
WiDi session.
I encounter connection failure with ScreenBeam Mini 2 and my device can't
connect to it any more.
Reboot the Receiver and try connecting again. Or, reboot your device and try
reconnecting.
Reboot both the Receiver and your device and try connecting again.
If you are using a Windows 8.1 operating system, go to Change PC settings > PC and
Devices > Devices > Projectors, then remove the profile of ScreenBeam Mini 2 from
your device, and try connection again.
I can't connect to the Receiver with ScreenBeam Configuration Utility on my
device. The Utility can't find the Receiver.
In Windows 8.1, you must connect your device to the Receiver at least once. In doing so, the
profile of the Receiver is saved to your device. Then the Utility on your device can connect to
the Receiver.
In Windows 7/8, you must connect your device to the Receiver with Intel WiDi first, and
then the Utility on your device can connect to the Receiver.
In Windows 8.1, I can't adjust the screen size with the ScreenBeam
Configuration Utility. I can't find the screen size adjustment option.
The screen size adjustment option is not available if your device doesn't connect to the
Receiver. You must connect your device to the Receiver first, and then launch the Utility and
configure the receiver.
22

Advertisement

Table of Contents
loading

Table of Contents