Desktop Charger Troubleshooting - Motorola iDEN i500plus User Manual

i500plus UserÕs Guide

Desktop Charger Troubleshooting

If the battery is not charging and you see:
A ßashing yellow indicator -
¥ The ßashing yellow LED is used to indicate that the ChargerÕs
pocket is in a wait state.
¥ If a battery is in the rear pocket, the rear pocketÕs LED
continues to ßash yellow until the battery in the front pocket is
more than 90% charged (front pocketÕs LED is solid green).
This is normal operation.
¥ To protect your batteryÕs life expectancy, the Charger does not
rapid charge a battery when its temperature is below 5
o
(41 F) or above 45
No LED indication -
¥ Check that the i500plus with battery, or a battery alone, is
inserted correctly.
¥ Make sure that the power supply is plugged into an appropriate
AC outlet and that the connector is properly seated.
¥ Rear pocket only: Remove the battery from the Charger. Use an
ordinary pencil eraser to clean the three metal contacts on the
battery and then place the battery in the Charger.
¥ If the LED indicator remains turned OFF, the battery may be
defective and should be replaced.
Flashing red LED indicator -
¥ Remove the battery from the Charger. Use an ordinary pencil
eraser to clean the three metal contacts on the battery and then
place the battery in the Charger.
¥ If the LED indicator remains turned OFF, the battery may be
defective and should be replaced.
Both LEDs ßash red -
¥ This indicates that the incorrect power supply is plugged in.
48
o o
C (113 F).
o
C