Siemens SITRANS L Operating Instructions Manual page 40

more detailed error messages available under the menu item ""Diagnostics" via the
respective adjustment module.
Status messages
The status messages are divided into the following categories:
•
•
•
•
and explained by pictographs:
1
2
3
4
Figure 9.1
Failure: Due to a malfunction in the transmitter, a fault signal is output.
This status message is always active. It cannot be deactivated by the user.
Function check: The transmitter is being worked on, the measured value is
temporarily invalid (for example during simulation).
This status message is inactive by default.
Out of specification: The measured value is unreliable because an transmitter
specification was exceeded (e.g. electronics temperature).
This status message is inactive by default.
Maintenance required: Due to external influences, the transmitter function is
limited. The measurement is affected, but the measured value is still valid. Plan in
maintenance for the transmitter because a failure is expected in the near future (e.g.
due to buildup).
This status message is inactive by default.
Failure
Code
Text message
F013
SITRANS LR100
Operating Instructions, 10/2021, 62705-76-01
Failure
Function check
Out of specification
Maintenance required
Failure - red
Out of specification - yellow
Function check - orange
Maintenance required - blue
Pictographs of the status messages
Cause
No measured value in the switch-on
phase or during operation
Diagnostics and troubleshooting
9.4 Status messages according to NE 107
Rectification
Check or correct installation and/or
parameter settings
33