Product Installation Guide - Navien EME501 User Manual

Product Installation Guide

When using a bed, put a bed cover over it and install a pad on it.
※ If you use an additional cover, you can use it more safely from
low-temperature burns.
1. Remove the protective film attached to the product before
installing the product.
2. Select a location to use.
Set the pad so that pad receptacle part is
located as shown in the figure below.
※ (Receptacle location – Single : Bottom right / Queen :
Bottom center) Keep the adapter and the pad at least
12 inches (30cm) apart and make sure neither of them is
covered by the blanket.
3. Plug in the connector to the receptacle of pad.
4. Plug in the other side of connector to the
adapter.
5. Connect the power cord of the adapter to an
outlet and turn on the power by pressing
the jog on the controller.
※ Use a grounded outlet. An ungrounded outlet may affect
the generation of electromagnetic waves (electric fields).
6. Set the desired temperature level.
To see how to set temperature, see the "How to Use the Product"
page.
When using the product, make sure that the controller is not
covered with a blanket.
12 inches
(30cm)
Top (head)
Bottom (leg)
Receptacle
Connector
11