45° Bevel Stop - Bosch GCM18V-12SD Operating/Safety Instructions Manual

Fig. 22
16099221PH GCM18V-12SD OSI 20220506.indd 25
Adjustments
45° Bevel Stop
Checking 45° Bevel Stop Setting
0° Bevel
Adjustment
1. Hold the saw head assembly (Fig. 21, 28)
Screw
down and push in the head assembly lock
pin (8) to keep the saw in the DOWN posi-
tion.
2. Slide the saw head assembly (28) complete-
ly to the back and tighten the slide rail lock
knob (7).
3. Rotate the table to the 0° miter position.
4. Rotate the bevel lock knob (Fig. 19, 34)
clockwise to unlock the head assembly.
5. Move the left sliding fence (Fig. 21, 12) fully
to the left.
6. Check the position of the bevel stop indica-
tor (Fig. 23, 33). It should be at the "45°"
position.
Fig. 23
7. Tilt the saw head assembly (Fig. 21, 28) to
the left (counterclockwise) until it hits the
45° stop. This is where the saw's 45° stop is
set to make a 45° left bevel cut.
8. Use a combination square to check that the
blade is 45° to the table. Remove the rule
blade from the combination square (Fig. 24).
Place only the combination square's head on
the saw's table with its long flat side rest-
ing on the table and its 45° side against the
tilted blade (25).
-25-
Lock nut
Bevel stop
bolt
33
5/6/22 12:15 PM