Fcc Caution - Bosch GBH18V-24C Operating/Safety Instructions Manual

Bluetooth®
Always check tool settings
before use. Settings may be
different than when the tool was last used. The
connectivity module enables transfer of data
and settings based on Bluetooth® wireless tech-
nology. With module installed, select tool set-
tings may be changed remotely by a paired Blue-
tooth® device and user installed app.
This tool is equipped with a
radio interface. Local oper-
ating restrictions, e.g. in military sites or hos-
pitals, are to be observed. Transmitters have
demonstrated an ability to unintentionally inter-
fere with other devices.
THINK SAFETY
SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TOOL IS BEING USED.

FCC Caution

The manufacturer is not responsible for radio
interference caused by unauthorized modifica-
tions to this equipment. Such modifications
could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interfer-
ence, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide rea-
sonable protection against harmful interference
in a residential installation. This equipment gen-
erates, uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instructions, may cause harmful
1605A000XG GBH18V-24C 202208.indd 19
page heading Connectivity
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equip-
ment does cause harmful interference to radio
or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
"Exposure to Radio Frequency (RF) Signals:
The wireless device is a radio transmitter and
receiver. It is designed and manufactured not
to exceed the emission limit for exposure to ra-
dio frequency (RF) energy set by the Ministry
of Health (Canada), Safety Code 6. These limits
are part of comprehensive guidelines and estab-
lished permitted levels of RF energy for the gen-
eral population.
These guidelines are based on the safety stan-
dards previously set by international standard
bodies. These standards include a substantial
safety margin designed to assure the safety of
all persons, regardless of age and health.
This device and its antenna must not be co-lo-
cated or operating in conjunction with any other
antenna or transmitter.
ISED Canada
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause unde-
sired operation of the device.
-19-
9/15/22 10:41 AM