Slip Clutch - Bosch GBH18V-24C Operating/Safety Instructions Manual

"Vario-Lock"
The Vario-Lock position is intended for use with
chipping bits such as bull points, spades, goug-
es, etc. Choose a position which is best suited
for your operation.
Turn the mode selector dial, to the "vario-lock"
setting. Next, rotate the locking sleeve, along
with the accessory, to the desired position.
Then turn the mode selector dial to the "ham-
mer only" setting and slightly turn the locking
sleeve to have it automatically lock into a defi-
nite position (Fig. 10).

Slip Clutch

The tool has a internal pre-set slip clutch. The
output spindle will stop rotating if the accessory
binds and overloads the tool.
Kickback Control
The rapid shut-off feature enables better control
and improves user's comfort. The power tool
automatically shuts off in case of sudden and
unexpected rotation of the power tool around
the drilling axis (for example jamming of the drill
bit in reinforcing steel or wedging application
tool).To restart the machine, release the On/Off
switch and then actuate again.
Kickack Control can activate only when the pow-
er tool is running at maximum operating speed
and can rotate freely around the drill bit axis.
Inserting and Releasing
Battery Pack
Set Forward/Reversing lever (8) to the center
(off position). Slide charged battery pack (11)
into the housing until the battery pack locks into
position.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from complete-
ly falling out of the handle, should it become
loose due to vibration.
To remove the battery pack, press the battery
pack release button (16) and slide the battery
pack completely out of tool housing (Fig. 11).
1605A000XG GBH18V-24C 202208.indd 15
Operating Instructions
Fig. 10
Fig. 11
-15-
9/15/22 10:41 AM