Connecting Your Scanner; Installation For Macintosh Computers With Built-In Scsi Ports; Connecting The Scanner - Microtek ArtixScan 6000XY Operation Manual

4 Connecting your scanner

This section provides information on installing the ArtixScan 6000XY on the
Macintosh. The procedures are divided into two main sections: 1) Installation for
Macintosh computers that feature built-in SCSI ports; and 2) Installation for the new
Macintosh G3/G4 computers with built-in USB ports. For the new G3/G4 computers,
you will be installing the SCSI interface card included in the scanner package.
Important: Before connecting, make sure that the computer, your scanner, and all other
devices are turned off.
Installation for Macintosh computers with built-in
SCSI ports
A. Connecting the scanner
1. Shut down your computer.
2. Connect the scanner to your computer, using the SCSI cable provided in the
scanner package.
Note: See the next section for details on termination
3. Plug the power cord to the power connector at the back panel of the scanner, and
plug the other end of the power cord to your AC power source or wall outlet.
4. Turn on your scanner and wait for all the lights on the front panel to stop blinking
and stay on steady.
5. Power up your Macintosh.
(1)
Connect the SCSI
cabl e t o t h e
Macintosh SCSI
port .
6
ArtixScan 6000XY Installation and Operation Manual 7