Positioning Transparent Film - Microtek ArtixScan 1800f Installation And Operation Manual

Positioning Transparent Film

This procedure applies when you use the lower scan bed of the ArtixScan 1800f,
which has a holder that is used for scanning transparent film.
There are two ways to scan transparent film.
A. By using the Glass Holder, which is used to scan non-standard-sized transparent
B. By using the Main Holder, which is used together with the individual holders to
Main Holder
Caution:
Make sure that the calibration slit faces the front of the scanner when you insert the
holder into the transparency bay (the drawer of lower compartment) of the scanner.
12 ArtixScan 1800f Installation and Operation Manual
film.
Glass Holder
Calibration slit
scan a particular type of standard-sized transparent film, such as individual 35mm
slides, 35mm filmstrips, 6 x 9 cm film, or 4" x 5" film.
4 " x 5 " Film Holder