Selecting The Spray Setting (Standard Spray Attachment); Adjusting The Material Volume (Wall Extra I-Spray Spray Attachment); Adjusting The Material Volume (Standard Spray Attachment); Setting The Amount Of Air (Fig. 11) - WAGNER W 590 FLEXIO Translation Of The Original Operating Instructions

EN
12. Selecting the Spray Setting
(Standard spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 7, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 8 A = vertical flat jet
Fig. 8 B = horizontal flat jet 
Fig. 8 C = circular jet
13. Adjusting the Material Volume
(Wall Extra I-Spray spray attachment)
The volume of material can be set by turning the material volume control (Fig. 9, 1) in
steps from 1 (minimum) to 12 (maximum).
14. Adjusting the Material Volume
(Standard spray attachment)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
(Fig. 10)
lower material volume
higher material volume

15. Setting the Amount of Air (Fig. 11)

Depending on the viscosity of the material to be sprayed and the finish of
i
the object to be coated, it may be advisable to vary the amount of air. Very
low viscosity materials, such as watery glazes do not have to be atomised
with the maximum amount of air. In this case it is advisable to reduce
the amount of air and thus minimize the spray vapour.
This also applies for the use of the Detail and Corner&Reach spray attachment
(accessory).
Turn the air quantity regulator (fig. 11, 1) until the level you want is above the arrow. Turn the air quantity regulator (fig. 11, 1) until the level you want is above the arrow.
28
for horizontal surfaces

for vertical surfaces
for corners, edges and hard-to-reach surfaces

turn anti-clockwise (-)

turn clockwise (+)

W 590 Flexio