Table of Contents
Advertisement
InsTallaTIon
InsTallaTIon
SECTIONS
Table of Contents
step 5 – Connecting the Computers
5.1 Using USB cables, connect each computer to the USB port in "computer
interface ports" area on product.
5.2 If computer uses audio output, e.g., speakers/headphones, connect audio cable
from its audio output port to the corresponding audio input port on product.
– Audio can be frozen on a channel (if equipped) and allow for the operator to
hear the frozen channel audio when switched to another channel. An audio
channel can be frozen by pressing and holding the channel button to be
frozen for 3 seconds. The audio freeze light will illuminate. To disable the
freeze, press and hold the channel button for 3 seconds. The freeze light
will extinguish.
5.3 If the computer uses a smart card/CAC reader, connect a USB cable between
the CAC-enabled computer and the corresponding CAC port on product.
note:
1.
If the number of channels is larger than the number of sources used, make
sure the computers are connected in a row starting from computer #1. For
example, if there are 3 channels used, connect computers to channels #1,
#2 and then #3.
2.
The USB cable must be connected directly to a free USB port on the
computer, with no USB hubs or other devices in between.
Powering Up the Computers
Power up all the attached computers and check for display and peripheral
functionality. All computers can be powered on simultaneously.
Belkin
Belkin
Universal 2nd Gen Secure DP/HDMI to DP/HDMI KVM Switch
Universal 2nd Gen Secure DP/HDMI to DP/HDMI KVM Switch
®
®
1
2
3
note: Your computers should recognize the Switch and automatically install the
HID USB driver if necessary.
When you power on your computers, the Switch emulates both a mouse and
keyboard on each port and allows your computers to boot normally. The computer
connected to port "1" will be displayed on the monitor. Check to see that the
keyboard, monitor, and mouse are working normally. Proceed to do this with all
occupied ports to verify that all computers are connected and responding correctly.
If you encounter an error, check your cable connections for that computer and
reboot. If the problem persists, please refer to the Troubleshooting section in this
User Manual.
18
4
5
6
7
baCK To Table of ConTenTs >
baCK To Table of ConTenTs >
Advertisement
Table of Contents
